Difference between revisions of "CS-LAMP-IR Data Sheet"
Jump to navigation
Jump to search
| Line 68: | Line 68: | ||
==Board Dimension== | ==Board Dimension== | ||
<br /> | <br /> | ||
| − | [[File:CS-LAMP-IR结构图纸.jpg|left|thumb|600x600px|CS-LAMP-IR CAD drawing | + | [[File:CS-LAMP-IR结构图纸.jpg|left|thumb|600x600px| CS-LAMP-IR CAD drawing / unit : mm|alt=]] |
<br /> | <br /> | ||
Revision as of 11:32, 10 December 2019
1 Introduction
The CS-LAMP-IR module is a light source for the camera module, which is started when the ambient light brightness is insufficient at night to provide necessary brightness for the camera and improve the imaging effect of the camera module.
The light source of the CS-LAMP-IR module is infrared light with a wavelength of about 850nm.The module has a built-in ambient illumination sensor.
When the ambient light reaches the specified illumination, the module automatically turns on the infrared light, and outputs a synchronization signals to the camera module to inform the camera module to switch day and night mode.
2 Technical Detail
| Technical Detail | |
|---|---|
| Power Supply | DC5V |
| Power Consumption | 550mW |
| Detection Wavelength | 390nm~700nm |
| IR LED Wave Length | 850nm |
3 Interface & Pin list
J1、J4 、J5 pins are connected in parallel, please choose them according to the situation.
J1
| 1 | DC 5V |
| 2 | GND |
J2
| 1 | NIGHT_O | Active High |
| 2 | GND | |
| 3 | NIGHT_O_n | Active Low, Open-Collector |
J4
| 1 | DC 5V |
| 2 | GND |
J5
| 1 | DC 5V |
| 2 | GND |
4 Board Dimension
