Line 20: |
Line 20: |
| | | |
| == Attention 注意事项 == | | == Attention 注意事项 == |
− | C-MOUNT01仅仅是一个C-MOUNT镜头固定座,为了适配MV系列和RAW系列的,实际后焦距离略小于17.5mm,配合不同型号的摄像机模组,需要将镜头略微向远离传感器的方向调整。具体数值需要根据传感器的成像面高度决定。
| |
| | | |
− | C-MOUNT01 is only a C-MOUNT lens mount. In order to fit the MV series and RAW series, the actual rear focal distance is slightly less than 17.5mm. With different camera modules, | + | === Overview 概述 === |
| + | C-MOUNT01仅仅是一个C-MOUNT镜头固定座,为了适配MV系列和RAW系列摄像机,'''''<u>实际后焦法兰焦距略小于17.526mm</u>''''',配合不同型号的摄像机模组,需要将镜头向远离传感器的方向调整。具体数值需要根据传感器的成像面高度决定。 |
| + | |
| + | C-MOUNT01 is only a C-MOUNT lens mount. In order to fit the MV series and RAW series camera, '''''<u>the actual Flange BFL distance is less than 17.526mm</u>'''''. With different camera modules, |
| + | |
| + | the lens needs to be adjusted away from the sensor. The specific value needs to be determined according to the sensor's imaging surface height. |
| + | {| class="wikitable" |
| + | !Not adjusted / 未调整 |
| + | !Adjusted / 向外调整 |
| + | |- |
| + | |[[File:C MOUNT-LENS 02.jpg|thumb]] |
| + | |[[File:C MOUNT-LENS 01.jpg|thumb]] |
| + | |} |
| + | |
| + | === 镜头向远离传感器方向偏移距离 “Da” 的计算:Calculation of lens offset distance “Da” away from the sensor === |
| + | '''<big>''Da = Dc - ( H - Ds )''</big>''' |
| + | |
| + | '''法兰后焦距 / Flange BFL''' :Dc = 17.526mm |
| + | |
| + | '''C-MOUNT01高度 / The Height of C-MOUNT01''':H= 18mm |
| + | |
| + | '''传感器底面到感光面的距离 / Distance from the bottom of the sensor to the effective image''' '''area''':Ds |
| + | {| class="wikitable" |
| + | |+ |
| + | Parameter 参数表 |
| + | |
| + | !Part NO. / 型号 |
| + | !Ds (mm) |
| + | !Da(mm) |
| + | |- |
| + | |[[MV-MIPI-IMX296M Index|MV-MIPI-IMX296M]] |
| + | |0.92 |
| + | |0.446 |
| + | |- |
| + | |[[MV-MIPI-IMX178 Index|MV-MIPI-IMX178M]] |
| + | |0.92 |
| + | |0.446 |
| + | |- |
| + | | |
| + | [[MV-MIPI-IMX265M Index|MV-MIPI-IMX265M]] |
| + | |0.92 |
| + | |0.446 |
| + | |- |
| + | | |
| + | [[MV-MIPI-IMX264M Index|MV-MIPI-IMX264M]] |
| + | |0.92 |
| + | |0.446 |
| + | |- |
| + | | |
| + | [[MV-MIPI-IMX287M Index|MV-MIPI-IMX287M]] |
| + | |0.92 |
| + | |0.446 |
| + | |- |
| + | | |
| + | [[RAW-MIPI-IMX462M Index|RAW-MIPI-IMX462M]] |
| + | |0.62 |
| + | |0.146 |
| + | |- |
| + | |[[MV-MIPI-SC130M Index|MV-MIPI-SC130M]] |
| + | |0.6 |
| + | |0.126 |
| + | |} |
| | | |
− | the lens needs to be slightly adjusted away from the sensor. The specific value needs to be determined according to the sensor's imaging surface height.
| |
− | <br />
| |
| ==Dimension 尺寸图== | | ==Dimension 尺寸图== |
| [[File:C-MOUNT01 Dimensional Drawing.pdf|center|thumb|1500x1500px|C-MOUNT01 Dimensional Drawing|alt=]] | | [[File:C-MOUNT01 Dimensional Drawing.pdf|center|thumb|1500x1500px|C-MOUNT01 Dimensional Drawing|alt=]] |