Difference between revisions of "CS-USB-IMX307"
Jump to navigation
Jump to search
| (2 intermediate revisions by one other user not shown) | |||
| Line 19: | Line 19: | ||
*Standard lens mount | *Standard lens mount | ||
*IR-CUT circuit | *IR-CUT circuit | ||
| − | + | *Brightness, Contrast, Sharpness, Saturation <br /> | |
| − | *Brightness, Contrast, Sharpness, Saturation | ||
==Thechnical Detail== | ==Thechnical Detail== | ||
| Line 58: | Line 57: | ||
|- | |- | ||
|Exposure | |Exposure | ||
| − | |Auto | + | |Auto |
|- | |- | ||
|White Balance | |White Balance | ||
| Line 72: | Line 71: | ||
|2D/3D noise reduction | |2D/3D noise reduction | ||
|- | |- | ||
| − | |Image | + | |Image Features |
|Brightness, Contrast, Sharpness, Saturation,Flip, Mirror | |Brightness, Contrast, Sharpness, Saturation,Flip, Mirror | ||
| − | |||
| − | |||
| − | |||
|- | |- | ||
|Day/Night Switch | |Day/Night Switch | ||
Latest revision as of 14:48, 23 August 2023
CS-USB-IMX307 Data Sheet
1 Introduction
CS-USB-IMX307 / CS-USB-IMX307-V2.0 is a cost-effective USB camera. This module use the SONY STARVIS CMOS image sensor IMX307LQD-C,built-in ISP processing.
Users can easily integrate into embedded systems or PC platforms via USB interface.
2 Features
- SONY IMX307 STARVIS Sensor, 1/2.8 inch 2 Mega
- Built-in ISP processing
- USB2.0 Interface,USB Video Class(UVC)
- Data fromat : YUY2 / MJPG / H.264
- Standard lens mount
- IR-CUT circuit
- Brightness, Contrast, Sharpness, Saturation
3 Thechnical Detail
| Technical Details | |
| SENSOR | |
| Sensor | SONY IMX307LQD-C STARVIS |
| Pixels | 2.07M pixels |
| Resolution | 1920*1080 MAX |
| Image Size | Diagonal 6.46 mm (Type 1/2.8) |
| Unit Cell Size | 2.9um (H)*2.9um(V) |
| SNR1s Value | 0.24lx |
| ISP | |
| YUY2 Frame Rate | 640*360@25fps / 30fps |
| MJPG Frame Rate | 1920*1080@25fps / 30fps, 1280*720@50fps / 60fps, 640*360@25fps / 30fps |
| H.264 Frame Rate | 1920*1080@25fps / 30fps, 1280*720@50fps / 60fps, 640*360@25fps / 30fps |
| Exposure | Auto |
| White Balance | Auto |
| Shutter | 1/25(1/30)s to 1/20,000s |
| Slow Shutter | N.A. |
| Denoising | 2D/3D noise reduction |
| Image Features | Brightness, Contrast, Sharpness, Saturation,Flip, Mirror |
| Day/Night Switch | Manual or IR-CUT filter with external trigger |
| Lens & IR-CUT | |
| Lens | Support M12*0.5 or M16*0.5 depend on lens mount |
| Lens Mount with IR-CUT | MTV12 or MTV16 |
| Mounting Hole | 2 screw holes with diameter of 2.2mm,20mm Center-to-Center Spacing |
| Interface | |
| Connector | MX1.25*4,USB2.0 Interface |
| Communication Interface | USB2.0,UVC Protocol |
| IR-CUT Control | IR-CUT motor control, 3.3VDC |
| Day/Night External Trigger | 3.3VDC to 5VDC compatibility |
| General | |
| Operating Conditions | -10℃~60℃, Humidity 95% or less, non-condensing |
| Power Supply | 5VDC |
| Power Consumption | 5VDC,1.5W without IRCUT，2W when Drive IRCUT |
| Dimension | 38mm*38mm*10mm(not include lens and lens mount) |
4 Interface & Pin list
| J1:USB2.0 Interface | ||
| Pin NO. | NAME | Remarks |
| 1 | VBUS(5VDC) | from USB HOST |
| 2 | D- | |
| 3 | D+ | |
| 4 | GND | |
| CS-USB-IMX307-V2.0 only have | ||
| J14:Micro B USB2.0 Interface | ||
| Pin NO. | NAME | Remarks |
| 1 | VBUS(5VDC) | from USB HOST |
| 2 | D- | |
| 3 | D+ | |
| 4 | GND | |
| 5 | ID | NC |
| J3:Power Input, Used during firmware upgrade | ||
| Pin NO. | NAME | Remarks |
| 1 | 5VDC | 5V IN |
| 2 | NC | |
| 3 | NC | |
| 4 | GND | |
| J4:Day/Night External Trigger | ||
| Pin NO. | NAME | Remarks |
| 1 | IR LED ON | INPUT，ACTIVE LOW |
| 2 | GND | |
| 3 | RESERVE | |
| J6:IRCUT Control | ||
| Pin NO. | NAME | Remarks |
| 1 | IRCUT1 | |
| 2 | IRCUT2 | |
| J6 IRCUT Control Functional specifications | ||||
| MODE | pin | Signal polarity | Image type | Filter position |
| Mode 1 | IRCUT1 | + | color | Infrared cutoff |
| IRCUT2 | - | |||
| Mode 2 | IRCUT1 | - | mono | Full wavelength pass |
| IRCUT2 | + | |||
| J7:Configurable GPIO ( RESERVE ) | ||
| Pin NO. | NAME | Remarks |
| 1 | GPIO0 | Can Be Configured |
| 2 | GND | |
| 3 | GPIO1 | Can Be Configured |
