Difference between revisions of "CS-LAMP-IR Data Sheet"
Jump to navigation
Jump to search
| Line 70: | Line 70: | ||
==Board Dimension== | ==Board Dimension== | ||
| − | [[File:CS-LAMP-IR CAD尺寸图.jpg|left|thumb|600x600px|CS-LAMP-IR CAD尺寸图]] | + | All data in millimeters are shown below.[[File:CS-LAMP-IR CAD尺寸图.jpg|left|thumb|600x600px|CS-LAMP-IR CAD尺寸图]] |
Revision as of 15:13, 2 December 2019
1 Introduction
The CS-LAMP-IR module is a light source for the camera module, which is started when the ambient light brightness is insufficient at night to provide necessary brightness for the camera and improve the imaging effect of the camera module.
The light source of the CS-LAMP-IR module is infrared light with a wavelength of about 850nm.The module has a built-in ambient illumination sensor. When the ambient light reaches the specified illumination, the module automatically turns on the infrared light, and
outputs a synchronization signals to the camera module to inform the camera module to switch day and night mode.
2 Technical Detail
| Technical Detail | |
|---|---|
| Power Supply | DC5V |
| Power Consumption | 550mW |
| Detection Wavelength | 390nm~700nm |
| IR LED Wave Length | 850nm |
3 Interface & Pin list
J1、J4 、J5引脚并联，可视情况选用。
J1
| 1 | DC 5V |
| 2 | GND |
J4
| 1 | DC 5V |
| 2 | GND |
J5
| 1 | DC 5V |
| 2 | GND |
J2
| 1 | NIGHT_O | High Level active |
| 2 | GND | |
| 3 | NIGHT_O_n | Complementary NIGHT_O, Open-Collector |
4 Board Dimension
All data in millimeters are shown below.
File:CS-LAMP-IR CAD尺寸图.jpg
CS-LAMP-IR CAD尺寸图