CS-USB-IMX307
1 Introduction
CS-USB-IMX307 is a cost-effective USB camera. This module use the SONY STARVIS CMOS image sensor IMX307LQD-C,built-in ISP processing.
Users can easily integrate into embedded systems or PC platforms via USB interface.
2 Features
- SONY IMX307 STARVIS Sensor, 1/2.8 inch 2 Mega
- Built-in ISP processing
- USB2.0 Interface,USB Video Class(UVC)
- Data fromat : YUY2 / MJPG / H.264
- Standard lens mount
- IR-CUT circuit
- BLC, Digtal WDR, 2D/3D noise reduction, Anti-fog
- Brightness, Contrast, Sharpness, Saturation adjustable
3 Thechnical Detail
| Technical Details | |
| SENSOR | |
| Sensor | SONY IMX307LQD-C STARVIS |
| Pixels | 2.07M pixels |
| Resolution | 1920*1080 MAX |
| Image Size | Diagonal 6.46 mm (Type 1/2.8) |
| Unit Cell Size | 2.9um (H)*2.9um(V) |
| SNR1s Value | 0.24lx |
| ISP | |
| YUY2 Frame Rate | 640*360@25fps / 30fps |
| MJPG Frame Rate | 1920*1080@25fps / 30fps, 1280*720@50fps / 60fps, 640*360@25fps / 30fps |
| H.264 Frame Rate | 1920*1080@25fps / 30fps, 1280*720@50fps / 60fps, 640*360@25fps / 30fps |
| Exposure | Auto or Manual |
| White Balance | Auto or Manual |
| Shutter | 1/25(1/30)s to 1/50,000s |
| Slow Shutter | Coming Soon |
| Denoising | 2D/3D noise reduction |
| Image Setting | Brightness, Contrast, Sharpness, Saturation,Flip, Mirror |
| Image Enhancement | BLC, Digtal WDR, Defog |
| Day/Night Switch | Manual or IR-CUT filter with external trigger |
| Lens & IR-CUT | |
| Lens | Support M12*0.5 or M16*0.5 depend on lens mount |
| Lens Mount with IR-CUT | MTV12 or MTV16 |
| Mounting Hole | 2 screw holes with diameter of 2.2mm,20mm Center-to-Center Spacing |
| Interface | |
| Connector | MX1.25*4,USB2.0 Interface |
| Communication Interface | USB2.0,UVC Protocol |
| IR-CUT Control | IR-CUT motor control, 3.3VDC |
| Day/Night External Trigger | 3.3VDC to 5VDC compatibility |
| General | |
| Operating Conditions | -10℃~50℃, Humidity 95% or less, non-condensing |
| Power Supply | 5VDC |
| Power Consumption | 5VDC,1.5W MAX |
| Dimension | 38mm*38mm*10mm(not include lens and lens mount) |
4 Interface & Pin list
4.1 J1:USB2.0 Interface
| 1 | VBUS(5V) |
| 2 | D- |
| 3 | D+ |
| 4 | GND |
4.2 J3:Power Input, Used during firmware upgrade
| 1 | 5VDC IN |
| 2 | NC |
| 3 | NC |
| 4 | GND |
4.3 J4:Day/Night External Trigger
| 1 | IR LED ON,Low level active |
| 2 | GND |
| 3 | RESERVE |
4.4 J6:IRCUT Control
| 1 | IRCUT1 |
| 2 | IRCUT2 |
4.5 J7:Trigger IN,Strobe OUT ( RESERVE )
| 1 | Trigger IN |
| 2 | GND |
| 3 | Strobe OUT |
5 Board Dimension
All data is in millimeters
File:CS-USB-IMX307 TOP CAD.pdf
CS-USB-IMX307 TOP CAD
6 Select a Lens for This Camera Module
The lens models listed below can be used with CS-USB-IMX307 module.