Line 570: |
Line 570: |
| Note: only supported on hdver >= 0x4 | | Note: only supported on hdver >= 0x4 |
| | | |
− | <br />
| + | ==== New function list ==== |
| + | The following new features are only supported in versions with ''release time'' later than 2022-11-22. |
| | | |
− | ==== 新功能 ==== | + | ===== paramsave ===== |
− | 下面的新功能,只有release time晚于2022-11-22的版本才支持。
| + | <code>./veye_mipi_i2c.sh -w -f paramsave</code> |
| + | |
| + | Save isp-related parameters to flash. |
| + | |
| + | ===== new_expmode ===== |
| + | <code>./veye_mipi_i2c.sh -r -f new_expmode</code> |
| + | |
| + | <code>./veye_mipi_i2c.sh -w -f new_expmode -p1 [0/1]</code> |
| + | |
| + | Whether the new version of manual exposure is enabled. |
| + | |
| + | If the new version manual exposure is enabled, then: |
| + | |
| + | # The original ''mshutter'' command is no longer in effect, ''new_mshutter'' takes effect. |
| + | # gain (agc) from automatic mode also changed to manual mode, ''new_mgain'' takes effect. |
| + | |
| + | ===== new_mshutter ===== |
| + | <code>./veye_mipi_i2c.sh -r -f new_mshutter</code> |
| + | |
| + | <code>./veye_mipi_i2c.sh -w -f new_mshutter -p1 1000</code> |
| + | |
| + | New version of manual exposure time configuration, in us in the range [1,1000000]. |
| + | |
| + | Since the sensor can not support accurate exposure time of 1us, it is recommended to read it for confirmation after configuration. |
| + | |
| + | ===== new_mgain ===== |
| + | <code>./veye_mipi_i2c.sh -r -f new_mgain</code> |
| + | |
| + | <code>./veye_mipi_i2c.sh -w -f new_mgain -p1 2.1</code> |
| + | |
| + | The new version manual gain, depending on the sensor, accurate to 0.1dB or 0.3dB. |