2,021
edits
Changes
Jump to navigation
Jump to search
Line 74:
Line 74: − + Line 82:
Line 82: − ===== 整体烧写 Flashing the Jetson Nano Development Kit =====+ − + − + − +
VEYE MIPI 290/327 for Jetson Nano/zh (view source)
Revision as of 11:58, 22 October 2019
, 11:58, 22 October 2019→动态升级
====使用编译好的程序====
====使用编译好的程序====
===== Installing the Kernel and DTS =====
=====Installing the Kernel and DTS=====
<code>cd $RELEASE_PACK_DIR/binaries</code>
<code>cd $RELEASE_PACK_DIR/binaries</code>
<code>tar -xzvf Image.tar.gz</code>
<code>tar -xzvf Image.tar.gz</code>
<code>sudo cp $RELEASE_PACK_DIR/binaries/tegra210-p3448-0000-p3449-0000-a02.dtb $L4T_DIR/kernel/dtb/tegra210-p3448-0000-p3449-0000-a02.dtb -f</code>
<code>sudo cp $RELEASE_PACK_DIR/binaries/tegra210-p3448-0000-p3449-0000-a02.dtb $L4T_DIR/kernel/dtb/tegra210-p3448-0000-p3449-0000-a02.dtb -f</code>
====整体烧写 Flashing the Jetson Nano Development Kit====
The steps to flash the Jetson Nano™ development kit are as follows:
The steps to flash the Jetson Nano™ development kit are as follows:
# Ensure a jumper is connected across J48 button header to enable DC power.
#Ensure a jumper is connected across J48 button header to enable DC power.
# Connect the micro USB cable to the Jetson Nano™ and host PC.
#Connect the micro USB cable to the Jetson Nano™ and host PC.
# Set the board to recovery mode, as mentioned in below steps:
#Set the board to recovery mode, as mentioned in below steps:
a. Power OFF the board.
a. Power OFF the board.