Line 20: |
Line 20: |
| *BLC, Digtal WDR, 2D/3D noise reduction, Anti-fog | | *BLC, Digtal WDR, 2D/3D noise reduction, Anti-fog |
| *Brightness, Contrast, Sharpness, Saturation adjustable | | *Brightness, Contrast, Sharpness, Saturation adjustable |
| + | *'''Support Multi-camera Module Video Stream Synchronization''' |
| *Support firmware upgrade via USB disk | | *Support firmware upgrade via USB disk |
| *Support Raspberry PI Platform, FPGA, ZYNQ,RK3399, NVIDIA JETSON Platform | | *Support Raspberry PI Platform, FPGA, ZYNQ,RK3399, NVIDIA JETSON Platform |
Line 77: |
Line 78: |
| |Day/Night Switch | | |Day/Night Switch |
| |Manual or IR-CUT filter with external trigger | | |Manual or IR-CUT filter with external trigger |
| + | |- |
| + | |Video Stream Synchronization |
| + | |'''Support Multi-camera Module Video Stream Synchronization''' |
| |- | | |- |
| | colspan="2" |'''Lens & IR-CUT''' | | | colspan="2" |'''Lens & IR-CUT''' |
Line 128: |
Line 132: |
| |1 | | |1 |
| |VBUS(5V) | | |VBUS(5V) |
− | | rowspan="4" |Connect the USB upgrade cable & USB storage | + | | rowspan="4" |Connect the USB upgrade cable & USB disk |
| |- | | |- |
| |2 | | |2 |
Line 200: |
Line 204: |
| | + | | | + |
| |} | | |} |
− | ===J7 : Trigger IN,Strobe OUT=== | + | ===J7 : Multi-function GPIO=== |
| {| class="wikitable" | | {| class="wikitable" |
| |1 | | |1 |
− | |Trigger IN | + | |GPIO0 |
| + | |Can Be Configured As Video Stream Synchronization Signal |
| |- | | |- |
| |2 | | |2 |
| |GND | | |GND |
| + | | |
| |- | | |- |
| |3 | | |3 |
− | |Strobe OUT | + | |GPIO1 |
| + | |Can Be Configured As Video Stream Synchronization Signal |
| |} | | |} |
| | | |