Line 1: |
Line 1: |
| + | <big>'''mv_mipi_i2c.sh Shell scripts usage'''</big> |
| | | |
| + | === Overview === |
| + | The mv_mipi_i2c.sh script is a tool set for configuring MV MIPI series cameras through the I2C. |
| + | |
| + | === Raspberry Pi Only, Set IO config === |
| + | Running |
| + | |
| + | <code>./enable_i2c_vc.sh</code> |
| + | |
| + | <code>./camera_i2c_config</code> |
| + | |
| + | first,it will config IO pin. Then you can run mv_mipi_i2c.sh. |
| + | |
| + | === mv_mipi_i2c.sh USAGE === |
| + | ./mv_mipi_i2c.sh |
| + | |
| + | Usage: ./mv_mipi_i2c.sh [-r/w] [-f] function name -p1 param1 -p2 param2 -b bus |
| + | |
| + | options: |
| + | |
| + | -r read |
| + | |
| + | -w write |
| + | |
| + | -f [function name] function name |
| + | |
| + | -p1 [param1] param1 of each function |
| + | |
| + | -p2 [param1] param2 of each function |
| + | |
| + | -p3 [param3] param3 of each function |
| + | |
| + | -p4 [param4] param4 of each function |
| + | |
| + | -b [i2c bus num] i2c bus number |
| + | |
| + | -d [i2c addr] i2c addr if not default 0x3b |
| + | |
| + | Please open this srcipt and read the COMMENT on top for support functions and samples |
| + | |
| + | ===i2c bus number on different board=== |
| + | Please refer to the following article to determine which -b parameter you need to use. |
| + | |
| + | [[I2c bus number and video node|i2c bus number on different boards]] |
| + | ===Functions list=== |