Line 137: |
Line 137: |
| <code>./cs_mipi_i2c.sh -r -f ispcap</code> | | <code>./cs_mipi_i2c.sh -r -f ispcap</code> |
| | | |
− | 获取当前模组支持的isp配置能力集,详细说明后续补充。
| + | 获取当前模组支持的isp配置能力集。 |
| + | |
| + | bit0 : CSC hue,contrast,saturation |
| + | |
| + | bit1 : AE auto exposure |
| + | |
| + | bit2 : ME manual exposure |
| + | |
| + | bit3 : AWB auto white balance |
| + | |
| + | bit4 : MWB manual white balance |
| | | |
| =====powerhz===== | | =====powerhz===== |
Line 218: |
Line 228: |
| | | |
| Note: only supported on camcap bit 0 is 1. | | Note: only supported on camcap bit 0 is 1. |
| + | =====daynightmode===== |
| + | <code>./veye_mipi_i2c.sh -r -f daynightmode</code> |
| + | |
| + | <code>./veye_mipi_i2c.sh -w -f daynightmode -p1 [value]</code> |
| + | {| class="wikitable" |
| + | !value |
| + | !description |
| + | |- |
| + | |0x1 |
| + | |Color Mode |
| + | |- |
| + | |0x2 |
| + | |Black&White Mode |
| + | |- |
| + | |0x0 |
| + | |Trigger Mode |
| + | |}IR-CUT (Infrared cut-off filter) is a mechanical shutter design. It is placed between the lens and the image sensor, and is controlled by a motor or an electromagnet. |
| + | |
| + | IR-CUT has two status: '''Block''' or '''Deliver''' the infrared. |
| + | |
| + | *Color Mode |
| + | |
| + | Image is Color Mode and IR_CUT status '''Block''' infrared. |
| + | |
| + | *Black&White Mode |
| + | |
| + | Image is Black&White Mode and IR_CUT status '''Deliver''' infrared. |
| + | |
| + | *Trigger Mode |
| + | |
| + | Trigger pin : [[CS-MIPI-IMX307 STARVIS Module|J4 pin1]]. |
| + | |
| + | Trigger pin High(3.3~12V),Image is Black&White Mode and IR-CUT status '''Deliver''' infrared. |
| + | |
| + | Trigger pin Low(GND),Image is Color Mode and IR-CUT status '''Bolck''' infrared. |