VEYE-MIPI-IMX335 Data Sheet
VEYE-MIPI-IMX335 DATA SHEET
1 Introduction
VEYE-MIPI-IMX335 is a starlight video streaming module, using a compact design (38*38*18mmm) to facilitate user integration, standard 15pin FPC user interface, easy access to embedded platforms such as raspberry pi and Nvidia.
The function of automatic power switch is added,5V and 3.3V power supply can be automatically switched to 5V power supply, or you can freely choose 5V or 3.3V independent power supply.
2 Features
- 1/2.8 inch 5Mega sensor IMX335LQN-C by SONY
- MIPI output: CSI-2
- Uncompressed UYVY format, YUV422-8bit
- IR-CUT circuit
- Stream mode
- BLC, 2D/3D noise reduction
- Brightness, Contrast, Sharpness, Saturation adjustable
- Support 5V - 3.3V access at the same time, automatic switch 5V power supply
- Also support 5V, 3.3V independent power supply (Pay attention to the power of the power supply terminal)
3 Thechnical Detail
| Technical Details | |
| SENSOR | |
| Sensor | SONY IMX335LQN-C STARVIS |
| Pixels | 5.04M pixel |
| Resolution | 2592(H) × 1944(V) |
| Image Size | Diagonal 6.52 mm (Type 1/2.8) |
| Unit Cell Size | 2.0 μm (H) × 2.0 μm (V) |
| Output Format | RAW Bayer |
| Shutter Type | Rolling Shutter |
| SNR1s Value | 0.33lx |
| ISP | |
| Frame Rate | 5M(2592x1944P)@20fps、5M(2592x1944P)@12.5fps
4M(2560x1440P)@30fps、4M(2560x1440P)@25fps |
| Exposure | Auto or FLK |
| White Balance | Auto or Manual |
| Shutter | 1/25(1/30)s to 1/50,000s |
| Slow Shutter | Support |
| Denoising | 2D/3D noise reduction |
| Image Setting | Brightness, Contrast, Sharpness, Saturation,Flip, Mirror |
| Image Enhancement | BLC |
| Day/Night Switch | Manual or IR-CUT filter with external trigger |
| Lens & IR-CUT | |
| Lens | MTV12 / MTV16 / CS |
| Lens Mount | M12*P0.5 / M16*P0.5 / CS，IRCUT is optional |
| Mounting Hole | 2 screw holes with diameter of 2.2mm,20mm Center-to-Center Spacing |
| Interface | |
| Connector | 15Pin 1.0mm pitch FPC, upper contact |
| Communication Interface | IIC, 3.3VDC |
| Video Data Interface | MIPI:2 Data Lanes@1188Mbps, CSI-2 YUV422-8bit Data Type |
| IR-CUT Control | IR-CUT motor control, 3.3VDC |
| Day/Night External Trigger | 3.3VDC to 12VDC compatibility |
| General | |
| Operating Conditions
(Bare PCB) |
-10℃~60℃, Humidity 95% or less, non-condensing |
| Power Supply | 5VDC / 3V3DC |
| Power Consumption | Usually: 1.6W@4M30fps
IR_CUT action switching moment: 2.1W MAX |
| Dimension | 38mm*38mm*18mm(not include lens and lens mount) |
4 Spectral Sensitivity Characteristics
| Sensor | Spectral Sensitivity |
| IMX335LQN-C |
5 Connector Pinlist
| J1:CSI-2 Interface | ||
| Pin NO. | NAME | Remarks |
| 1 | GND | |
| 2 | MIPI_L0_N | |
| 3 | MIPI_L0_P | |
| 4 | GND | |
| 5 | MIPI_L1_N | |
| 6 | MIPI_L1_P | |
| 7 | GND | |
| 8 | MIPI_CK_N | |
| 9 | MIPI_CK_P | |
| 10 | GND | |
| 11 | RST | Active Low，reset camera module |
| 12 | NC | |
| 13 | SCL | 3.3V level |
| 14 | SDA | 3.3V level |
| 15 | VCC3V3 | PWR IN |
| J4 : Day/Night External Trigger | ||
| Pin NO. | NAME | Remarks |
| 1 | Day&Night Signal In | INPUT，Active Low（Image to MONO），3.3VDC to 12VDC compatibility |
| 2 | GND | |
| 3 | IMAGING STATUS | OUTPUT，3.3V：Color；0V：MONO |
| J3 : IRCUT Control Functional specifications | |||||
| MODE | Pin NO. | PIN NAME | Signal polarity | Image type | Filter position |
| Mode 1 | 1 | IRCUT1 | - | color | Infrared cutoff |
| 2 | IRCUT2 | + | |||
| Mode 2 | 1 | IRCUT1 | + | mono | Full wavelength pass |
| 2 | IRCUT2 | - | |||
| J7：5VDC INPUT | ||
| Pin NO. | NAME | Remarks |
| 1 | 5VDC | |
| 2 | GND | |
| J5：Auxiliary IIC | ||
| Pin NO. | NAME | Remarks |
| 1 | AUX_SCL | |
| 2 | GND | |
| 3 | AUX_SDA | |
6 Board Dimension
