2,021
edits
Changes
Jump to navigation
Jump to search
Line 228:
Line 228: − + Line 234:
Line 234: − + Line 259:
Line 259: − + Line 494:
Line 494: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
→sreg
读取当前的码流模式和主从模式
读取当前的码流模式和主从模式
* freerunning模式
*freerunning模式
<code>./cs_mipi_i2c.sh -w -f streammode -p1 0</code>
<code>./cs_mipi_i2c.sh -w -f streammode -p1 0</code>
配置摄像头为freerunning模式
配置摄像头为freerunning模式
* sync模式
*sync模式
slave mode(sync stream mode)
slave mode(sync stream mode)
Note: only supported on camcap bit 0 is 1.
Note: only supported on camcap bit 0 is 1.
* Trigger 模式
*Trigger 模式
<code>./cs_mipi_i2c.sh -w -f streammode -p1 2</code>
<code>./cs_mipi_i2c.sh -w -f streammode -p1 2</code>
r sensor addr 0x300a value 0x3c
r sensor addr 0x300a value 0x3c
===== striggerone =====
<code>./cs_mipi_i2c.sh -w -f striggerone</code>
Software Trigger模式下，通过写寄存器，触发一次曝光和图像。
note: 仅CS-MIPI-SC132支持。
===== triggeredge =====
<code>./cs_mipi_i2c.sh -w -f triggeredge -p1 [value]</code>
<code>./cs_mipi_i2c.sh -r -f triggeredge</code>
{| class="wikitable"
|+TrigEdge
!value
!description
|-
|0
|上升沿触发
|-
|1
|下降沿触发
|}
===== tgdebncr =====
===== tgdly =====
===== pickmode =====
===== pickone =====
===== sysreboot =====